LINK Ballast Resistor (BAL6) ECU Master ECU

LINK Ballast Resistor (BAL6) ECU Master ECUFor use with low impedance injectors. Compatible with injectors with impedance between 2 and 6 Ohms. Please contact us if you are planning on using injectors with an impedance of less than 2 ohms. Includes set of 6 x 4. 7ohm 25w resistors mounted to a heatsink. These are also sold in a set of 4. Note that injector ballast resistors get quite hot at high injector duty cycles. These should stay mounted on the supplied heat sink and be bolted to the

The external electronic throttle control module can be wired as in output interface for ECUs that do not support electronic throttle control internally

Flex fuel sensor

Requires 'A' & 'B' Looms or 'A' & 'B' Pin Kits

Includes a single 1 Ohm 50W resistor mounted to a heatsink

Walbro performance fuel systems are designed to deliver the speed

and GST520

Inlet / Outlet : SAE 9

All output state

The EMU PRO is a stand-alone engine management system aimed directly at professional motorsport with a comprehensive feature set and vast tuning possibilities

MAC 45 series

8 x Auxiliary outputs^

This makes it ideal for naturally aspirated or turbocharged engines that just need a retune and one or two extra features