PYLON MOUNT WINCH ANCHORING SYSTEM Pulleys & Biners

PYLON MOUNT WINCH ANCHORING SYSTEM Pulleys & BinersDESCRIPTION This anchoring system is designed to anchor different models of winches directly to the main frame of a 90 V shaped pylon. It is the basis of different combinations of accessories. It is easily installed by one person thanks to the integrated magnets at the back of the support that keep it in place during the installation. No tools required for installation! For all winches. SPECIFICATIONS Will grip on most steel angles from 10 cm to 30

lowering and holding loads safely

by default

Ø10 MM = 200 M

In these cases

Two molded handles integrated to the box facilitate its handling

it includes a 12mm bent pin and an 'R' tie

where it is subject to friction and intense heat

• To pull a vehicle with another vehicle

Able to pull 1000 kg in a single line

This pivoting device then acts as the link between the vertical pull support and other anchoring devices

Specifically designed for lifting needs in the industrial sector

Its low cost and resistance to abrasion make it a good choice for using with our capstan winches