MSD - CAN-Bus Terminator cap for use with CAN-Bus Hub.Must be used with CAN Bus Hub, PN 7740 to complete circuit. Without the CAN Bus Terminator in place at the end of the CAN Bus system, signals could be distorted. These distorted signals could result in permanent or intermittent problems that include but are not limited to, improper timing, false signals, and repetitious signals. Always be sure to have the MSD Controller and the CAN Bus Terminator at the ends of the MSD CAN Bus.
Spring Shackle and Hanger - 4 in Lowering - Bushings / Hardware - Steel - Black Powder Coat - GM Fullsize Truck 1988-98 - Kit
000 in Thick - 5 x 5
Breather - Clamp-On - Round - Axle Assembly - 1-1/2 in OD Tube - 36 in Hose / Remote Tube Mount Bracket Included - Aluminum - Black Anodized - Kit
Folding Table - Work Table - 72 x 31 x 31 in - Aluminum - Natural - Each
Oil Filter - Canister - Screw-On - 4
Alternator Bracket - Passenger Side - Low Mount - Water Pump / Exhaust Mount - Steel - Natural - Short Water Pump - GM Alternator - Small Block Chevy - Kit
502 in OD - Manganese - Bronze - Each
Tire Pressure Gauge Holder - Wall Mount - Aluminum - Natural - Intercomp Square Digital Tire Gauges - Each
Intake Manifold - Performer RPM Pontiac - Spread / Square Bore - Dual Plane - Aluminum - Natural - Pontiac V8 - Each
Fitting - Adapter - Straight - 6 AN Male to 3/8 in NPT Male - Aluminum - Nickel Plated - Each
Adding to this strength are two sealed ball bearings that guide the 0
25 in ID - 6 in Length - 1200 lb/in Spring Rate - Steel - Blue Powder Coat - Each
